AUTONET TV

No Fueling! (Fuel Filler Location)

If you've ever gotten in an unfamiliar vehicle, maybe a rental car, you may have pulled up to the gas pump and wondered, "Which side is the fuel filler on?" Here's a tip for you.  There is usually a little arrow on the instrument panel near the fuel gauge that points to the side where the fuel filler is. 

But why are the fuel fillers not all on the same side, anyway? There are lots of reasons.  At one time, many manufacturers tried putting them in an easy-to-reach spot: in the center of the vehicle's rear end.  Some even hid them behind a hinged license plate door.  Cool place, but it turned out not to be a good idea.  When a vehicle with a fuel filler in the rear was hit by another vehicle from behind, it was much more prone to catch fire and explode.

Safety regulations now dictate that the fuel filler doors be placed within crumple zones and away from where they can drip fuel on hot exhaust pipes or near electrical connections.  But why do manufacturers put them on either side?

Some say it should be on the side away from the road.  That way if you run out of gas and have to add a little from a gas can as your standing at the side of the road, you'll be a little farther away from passing traffic.  So some companies from North America and many European firms with left-hand drive put their fillers on the right side.

Some manufacturers think convenience for the driver is paramount, so they put their fuel fillers on the driver's side.  If you have a vehicle with a cable release for the fuel door inside the cabin, it's usually on the same side as the steering wheel.  As you can see, there's no standardization.

Fuel doors need regular maintenance such as lubrication, and your gas cap (if your vehicle has one) should seal properly.  Have your service facility inspect those regularly. Wherever your fuel filler is, it's obviously important that you can get at it easily because you have to fuel up sometime. Otherwise, you're not going to go too far!

Auto Authority LLC
804 Witzel Ave
Oshkosh, Wisconsin 54902
920-231-1016
http://www.autoauthorityoshkosh.com

Not a Good Vibe (Driveshaft Failure)

When you feel your vehicle vibrating as you're driving down the road, one cause could be something you may not have ever seen: your driveshaft.  It is underneath the vehicle and most drivers don't climb under there to take a look very often.  The driveshaft is a cylindrical part that helps conduct the rotational power from your engine to your drive wheels.  If you have a four-wheel drive vehicle, you may have two driveshafts. 

The drive shaft has bushings, and when they wear out, that's a likely source of the vibrations.  When the bushings are in good condition, they prevent the driveshaft from vibrating.  And if you don't get your vehicle repaired fairly soon after discovering vibrations, they'll continue to get worse and cause other components of the drivetrain to wear out.

The driveshaft is, of course, only one part of the drivetrain.  It includes other parts such as axles, transmission, differentials and joints.  They all work together and need to be maintained properly.  When a driveshaft fails, there can be symptoms other than vibrations.  They include difficulty turning, rattles, clunks and squeaks coming from underneath your vehicle. You may even feel a shudder when you accelerate from a stop.

Driveshafts can fail when they get corroded or damaged by rough roads, curbs and debris. A trained technician with experience working on drivetrains uses specialized equipment that doesn't further damage the drivetrain's other parts.  Sometimes the entire driveshaft will have to be replaced; sometimes the problems can be fixed by replacing individual components. 

Your vehicle's drivetrain was engineered to propel you smoothly down the road.  When time and distance begin to take their toll, have your vehicle looked at by your service facility. They'll know how to properly pinpoint what's causing your problems and restore your vehicle to the reliable, smooth, safe machine its designers worked hard to create.

Auto Authority LLC
804 Witzel Ave
Oshkosh, Wisconsin 54902
920-231-1016
http://www.autoauthorityoshkosh.com

Idle Talk about Engines (Causes of Rough Engine Idling)

When you slow down at stoplight, your vehicle's idle should be smooth as silk.  But what happens when the engine is missing or idling roughly? That's your engine's way of telling you, "Hey, I've got something wrong with me and if you don't get someone to find out what it is, I may not start the next time you turn the key."

You can help your service facility if you can describe the problem in detail.  Here's a list of things to make a note of:

• When is the problem happening, when the engine is cold or when it's been running for a while?
• Does the rough idling occur when I'm accelerating or when I'm going at a steady speed?
• Does it happen at high speeds?  Does it happen low speeds? Does it happen at both?

Make sure you describe the problem in as much detail because it will help a technician diagnose the problem.

One of the first things they'll check is how the spark plugs are firing.  Modern iridium plugs are supposed to last a long, long time.  But they CAN eventually wear out.  Inspecting the firing end can help the technician figure out the root of the problem.  Corroded or worn out spark plug wires, too, can contribute to an idling irregularity. 

There are other potential problem spots, too.  The technician may check the ignition coil, timing piston rings, valves and cylinder walls. 

If the mixture of air and fuel isn't correct, that may affect how smooth your vehicle is running.  Your service facility is equipped with diagnostic equipment that helps them pinpoint the problem.  Once that idle is smoothed out to the way it used to be, you'll be the smoothest operator on the road.

Auto Authority LLC
804 Witzel Ave
Oshkosh, Wisconsin 54902
920-231-1016
http://www.autoauthorityoshkosh.com

The Turn Signal Mystery (Turn Signal Problems)

Some problems are easy to diagnose on a vehicle; others aren't.  Figuring out what's wrong with a malfunctioning turn signal sometimes fits into both categories.  By the way, if your tempted to just leave your broken blinker broken, remember you can get a ticket for not using them, not to mention you are missing a great chance to communicate your intentions to other drivers on the road.

There can be lots of signals that your signals are on the blink.  Does only the driver's side signal not work or the passenger's side? Do your hazard signals work? Do the lights illuminate but not flash? Can you see the indicators on the dash blinking? Do your turn signals turn off after you've finished your turn or do they stay on?  These are all great clues for the technician.

Here's one common symptom to take note of.  Your signal all of a sudden starts blinking much more quickly than it used to.  It could be a simple as a burned out bulb.  But there are many different parts that go into the turn signal system.  There are fuses that blow, switches that can fail, flasher modules that go bad and light bulb sockets that can simply get corroded or dirty.  When that happens, it's possible there's no contact between the bulb and the socket.

So it's understandable how tracking down the source of the problem can involve some detective work.  Your service facility has equipment that can nail down the cause of your problems. They may also consult the repair manual.  One thing to be aware of: if your vehicle has airbags, they may have to be disabled so they don't accidentally go off.

You can make sure your turn signals are working correctly by having them checked by a trained technician.  Other drivers will thank you for showing them the courtesy of signaling your intentions.  It's a courteous and considerate thing to do, not to mention it makes the road a safer place. 

Auto Authority LLC
804 Witzel Ave
Oshkosh, Wisconsin 54902
920-231-1016
http://www.autoauthorityoshkosh.com